Hi Eleanor,
Thank you for your information. I did do the B factor refinement in CCP4i and
at the first several rounds of refinement, there was no such difference map but
in the almost final run of refinement (including TLS and restrained), it
appeared. The B-factors (about 40) are similar to nearby residues. This
confused me. Any ideas?
Thank you again for your suggestions.
Best,
Sun Tang
Eleanor Dodson <[EMAIL PROTECTED]> wrote: Hard to say without more information.
Have you refined the B factors for these residues? Most building
software gives some arbitrary b value, which must then be refined. (In
fact after any rebuilding activity you need to do a few cycles of
refinement before looking at the maps again)
Eleanor
Sun Tang wrote:
> Hello Everyone,
>
> When I refined a structure, I found strong difference density Fo-Fc at 3
> sigma contour for the for five residues which already have occupancy of 1.
> The density is continuous and so strong as if I did not put the residues
> there. Why was that? Can I put greater than 1 occupancy for those residues?
>
> Thank you very much for your opinions and suggestions!
>
> Best wishes,
>
> Sun Tang
>
>
> ---------------------------------
> Never miss a thing. Make Yahoo your homepage.
>
---------------------------------
Never miss a thing. Make Yahoo your homepage.
