Why is ICMP size set to 46 bytes? Bob -- Sent from my iPhone, please excuse any typos.
On Mar 13, 2012, at 7:03 AM, Waleed Alsherif <[email protected]> wrote: > Hi All > > I am trying to limit an ICMP traffic from R1 to R2 , where R2 ping R1 with > ICMP packet size 64Byte , I would to configure R1 rate-limit to make the > success rate 97% ? > > I used this configuration and test but it is not working " > > R1 : > interface s0/0 > rate-limit input 8000 1000 2000 conform-action transmit exceed-action drop // > minimal values > > > R2: > R2(config-if)#do ping 1.1.1.1 si 46 rep 100 > > Type escape sequence to abort. > Sending 100, 46-byte ICMP Echos to 1.1.1.1, timeout is 2 seconds: > !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! > !!!!!!!.!!!!!!!!!!!!!!!!!!!!!! > Success rate is 98 percent (98/100), round-trip min/avg/max = 1/5/68 ms > > > What is your advice ? > > Best Regards > Waleed Abdulfattah Alsherif > IP and Data Network Engineer > CCIE RS (Written) / CCNP / CCNA > Mob. 002-01019556246 > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com > > http://onlinestudylist.com/mailman/listinfo/ccie_rs _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs
