Hi All I am trying to limit an ICMP traffic from R1 to R2 , where R2 ping R1 with ICMP packet size 64Byte , I would to configure R1 rate-limit to make the success rate 97% ?
I used this configuration and test but it is not working " R1 : interface s0/0 rate-limit input 8000 1000 2000 conform-action transmit exceed-action drop // minimal values R2: R2(config-if)#do ping 1.1.1.1 si 46 rep 100 Type escape sequence to abort. Sending 100, 46-byte ICMP Echos to 1.1.1.1, timeout is 2 seconds: !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! !!!!!!!.!!!!!!!!!!!!!!!!!!!!!! Success rate is 98 percent (98/100), round-trip min/avg/max = 1/5/68 ms What is your advice ? Best Regards Waleed Abdulfattah Alsherif IP and Data Network Engineer CCIE RS (Written) / CCNP / CCNA Mob. 002-01019556246 _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs
