Hi guys, I configured my multilink interfaces for both R6 AND R9, this is regarding vol.1 lab12, however, sitll my neighbor relationship is not established, and I am sure 100% my config are right.
below are my configuration R6 interface Multilink69 ip address 150.100.169.6 255.255.255.0 ip ospf cost 4713 ppp multilink ppp multilink group 69 end router ospf 1 router-id 10.10.6.6 log-adjacency-changes network 10.10.6.6 0.0.0.0 area 0 network 150.100.100.6 0.0.0.0 area 0 network 150.100.169.0 0.0.0.255 area 69 R6(config)# Neighbor ID Pri State Dead Time Address Interface 10.10.5.5 1 FULL/DR 00:01:37 150.100.100.5 Serial0/1 ------- > no signe for R9 R9 R9(config)#do sh run int multilink69 Building configuration... Current configuration : 127 bytes ! interface Multilink69 ip address 150.100.169.9 255.255.255.0 ip ospf cost 4713 ppp multilink ppp multilink group 69 end R9(config)#do sr | s os hostname R9 ip ospf cost 4713 router ospf 1 log-adjacency-changes passive-interface default no passive-interface FastEthernet0/0 no passive-interface Multilink69 network 150.100.169.0 0.0.0.255 area 69 R9(config)#do sh ip os ne Neighbor ID Pri State Dead Time Address Interface 10.10.6.6 0 INIT/ - 00:00:36 150.100.169.6 Multilink69 -------- } neighboring relationship is still no established yet. thanks, khaled _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs
