Waleed, Reflector port is a reminiscent of an age gone by. It's no longer required by the equipment in the CCIE lab (Cat 3560).
-- Marko Milivojevic - CCIE #18427 (SP R&S) Senior CCIE Instructor - IPexpert On Sun, Mar 11, 2012 at 05:03, Waleed Alsherif <[email protected]> wrote: > Hi all > > I would like to know what is the reflector-port in the command of RSPAN : > > Is it the output interface of the monitored VLAN ? or the remote interface of > the remote switch where the sniffer device is located ? > > > Example ( for using 3550 as SW1 & 3560 AS SW2 ) : > > R1 > | > f0/1 vlan 4 > | > R4 f0/0---- f0/4-vlan 4 -[SW1] ---Trunk- PO2------[ SW2]---- > f0/8-Vlan8-------f0/0-R8 ( sniffer ) > > on SW1 : > vlan 500 > remote-span > monitor session 1 source vlan 4 rx > monitor session 1 destination vlan 500 reflector-port ???? > > on SW2 : > vlan 500 > remote-span > monitor session 1 source remote vlan 500 > monitor session 1 destination interface f0/0 > > > > Best Regards > Waleed Abdulfattah Alsherif > IP and Data Network Engineer > CCIE RS (Written) / CCNP / CCNA > Mob. 002-01019556246 > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com > > http://onlinestudylist.com/mailman/listinfo/ccie_rs _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs
