Hi all I would like to know what is the reflector-port in the command of RSPAN :
Is it the output interface of the monitored VLAN ? or the remote interface of the remote switch where the sniffer device is located ? Example ( for using 3550 as SW1 & 3560 AS SW2 ) : R1 | f0/1 vlan 4 | R4 f0/0---- f0/4-vlan 4 -[SW1] ---Trunk- PO2------[ SW2]---- f0/8-Vlan8-------f0/0-R8 ( sniffer ) on SW1 : vlan 500 remote-span monitor session 1 source vlan 4 rx monitor session 1 destination vlan 500 reflector-port ???? on SW2 : vlan 500 remote-span monitor session 1 source remote vlan 500 monitor session 1 destination interface f0/0 Best Regards Waleed Abdulfattah Alsherif IP and Data Network Engineer CCIE RS (Written) / CCNP / CCNA Mob. 002-01019556246 _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs
