As mentioned in the attached diagram the interfaces are physical interfaces not sub-interface but dont you think there are the chances of loops, if i'll not enable the split-horizon on these physical interfaces on point to point FR Network, as by defult in RIP on serial frame-relay interface the Split horizon is disabled
Thanks & Regards Date: Wed, 1 Jul 2009 07:00:02 -0600 Subject: Re: [OSL | CCIE_RS] plz suggest (RIP ) From: [email protected] To: [email protected] CC: [email protected] M Jay, Have you labbed this yet?. If you are using point to point subinterfaces, you do not need to disable split horizon. On Wed, Jul 1, 2009 at 6:31 AM, M Jay <[email protected]> wrote: Hi, I have question that if RIP is running on frame-relay interfaces in point to point network then what is recommended to enable or to disable IP Split-Horizon on point to point network over FR or what is the default behavior? should we run this command IP Split-Horizon on RI & R3 S0/0 intefaces, (Fig. Attached) on Router RI & R3 interface s0/0 ip split-horizon please suggest.... Thanks & Regards M. Jay Windows Live™: Keep your life in sync. Check it out. -- Bryan Bartik CCIE #23707 (R&S), CCNP Sr. Support Engineer - IPexpert, Inc. URL: http://www.IPexpert.com _________________________________________________________________ Windows Live™: Keep your life in sync. http://windowslive.com/explore?ocid=TXT_TAGLM_WL_BR_life_in_synch_062009
<<attachment: dig.jpg>>
