ok thanks very much. For the second point, is it documented in the usermanual?
Regards, Le 24/04/2016 22:23, Dave Mielke a écrit : > [quoted lines by MENGUAL Jean-Philippe on 2016/04/24 at 21:14 +0200] > >> How can I, from brltty.conf: >> - run brltty with 2 braille displays. If I specify 2 braille-driver >> lines, just the 2nd is considered. > > You need two different files. Use brltty's -f option to point to the one > you'd > like each of them to use. Run two different brlttys, like this: > > brltty -f /etc/brltty1.conf > brltty -f /etc/brltty2.conf > >> - request brltty for searching on ttyS0, ttyUSB0, then connecting on the >> 1st which is working (e.g. ttyS0 or ttyUSB0 if an adapter is used). > > Specify two devices, separated by a comma. Like this: > > braille-device serial:ttyS0,serial:ttyUSB0 > -- Jean-Philippe MENGUAL HYPRA, progressons ensemble Tél.: 01 84 73 06 61 Mail: cont...@hypra.fr Site Web: http://hypra.fr _______________________________________________ This message was sent via the BRLTTY mailing list. To post a message, send an e-mail to: BRLTTY@mielke.cc For general information, go to: http://mielke.cc/mailman/listinfo/brltty
