[quoted lines by MENGUAL Jean-Philippe on 2016/04/24 at 21:14 +0200] >How can I, from brltty.conf: >- run brltty with 2 braille displays. If I specify 2 braille-driver >lines, just the 2nd is considered.
You need two different files. Use brltty's -f option to point to the one you'd like each of them to use. Run two different brlttys, like this: brltty -f /etc/brltty1.conf brltty -f /etc/brltty2.conf >- request brltty for searching on ttyS0, ttyUSB0, then connecting on the >1st which is working (e.g. ttyS0 or ttyUSB0 if an adapter is used). Specify two devices, separated by a comma. Like this: braille-device serial:ttyS0,serial:ttyUSB0 -- Dave Mielke | 2213 Fox Crescent | The Bible is the very Word of God. Phone: 1-613-726-0014 | Ottawa, Ontario | http://Mielke.cc/bible/ EMail: d...@mielke.cc | Canada K2A 1H7 | http://FamilyRadio.org/ _______________________________________________ This message was sent via the BRLTTY mailing list. To post a message, send an e-mail to: BRLTTY@mielke.cc For general information, go to: http://mielke.cc/mailman/listinfo/brltty
