Hi all, When pluging my braille note into my box with a usb to serial (and an adapter) (So it will connect since the port on the end of the cable is not different so won't connect to the BN) I then plug the usb end into my usb port. $ sudo dmesg | less
The last two lines I see are: usb 1-1: new full speed USB device using uhci_hcd and address 13 usb 1-1: configuration #1 chosen from 1 choice pl2303 1-1:1.0: ch341-uart converter detected usb 1-1: ch341-uart converter now attached to ttyUSB1 So I assume it is detected and run: brltty -b bn -d ttyUSB1 Then brltty -b bn -d ttyUSB0 Am I missing something? would BRLTTY be looking at my /etc/brltty.conf file instead of the arguments I give? I don't get braille... Thanks for any help! Or is this a braille note issue? -- Daniel Dalton http://members.iinet.net.au/~ddalton/ <[EMAIL PROTECTED]> _______________________________________________ This message was sent via the BRLTTY mailing list. To post a message, send an e-mail to: BRLTTY@mielke.cc For general information, go to: http://mielke.cc/mailman/listinfo/brltty
