On Wed, Jan 14, 2015 at 1:33 PM, M Hickman <[email protected]> wrote:
> Thank you, Robert. I appreciate you adding a ros-hydro config! > > I followed your instructions (under 14.04 on the Black). I dd'd the image > to the SD card booted it. The flasher started and then halted with a kernel > panic. I tried re-writing the image to the SD card using my Mac, with the > same result. > > I looked through the forums for clues. I copied > BBB-eMMC-flasher-ubuntu-14.04.1-console-armhf-2015-01-06-2gb.img to the SD > card, booted it and it flashed the eMMC just fine, so it's not a faulty SD > card. I am powering the board with a 5V supply that came with the board and > have nothing else attached. Not sure where to go from here. > > My FTDI cable is at the office, so I've attached a photo of the HDMI > output. The final lines before the kernel panic are: > No worries about the ftdi, everything is mirrored to the hdmi now. ;) > > ---------------- > Formatting: /dev/mmcblk1 > [ ] mmcblk1: unknown partition table > [ ] mmcblk1: p1 > mkfs.ext4 /dev/mmcblk1p1 -L BOOT > [ ] Kernel panic - not syncing: Attempted to kill init! exitcode=0x00000100 > > Suggestions? > What's odd, it's failing so early. Does it always stop at the same place. (you don't have to re0image the microSD card).. For clarification (and i'll test here) what was the file name of the flasher that is failing? Regards, -- Robert Nelson http://www.rcn-ee.com/ -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
