Thank you, Robert. I appreciate you adding a ros-hydro config! I followed your instructions (under 14.04 on the Black). I dd'd the image to the SD card booted it. The flasher started and then halted with a kernel panic. I tried re-writing the image to the SD card using my Mac, with the same result.
I looked through the forums for clues. I copied BBB-eMMC-flasher-ubuntu-14.04.1-console-armhf-2015-01-06-2gb.img to the SD card, booted it and it flashed the eMMC just fine, so it's not a faulty SD card. I am powering the board with a 5V supply that came with the board and have nothing else attached. Not sure where to go from here. My FTDI cable is at the office, so I've attached a photo of the HDMI output. The final lines before the kernel panic are: ---------------- Formatting: /dev/mmcblk1 [ ] mmcblk1: unknown partition table [ ] mmcblk1: p1 mkfs.ext4 /dev/mmcblk1p1 -L BOOT [ ] Kernel panic - not syncing: Attempted to kill init! exitcode=0x00000100 Suggestions? Thanks, Mike <https://lh5.googleusercontent.com/-2o5IwDZkgA8/VLbCDsqMfTI/AAAAAAAAAAw/EYzeHIR7Oyk/s1600/IMG_1823.JPG> On Monday, January 12, 2015 at 7:22:44 PM UTC-5, RobertCNelson wrote: > > On Mon, Jan 12, 2015 at 5:17 PM, Robert Nelson <[email protected] > <javascript:>> wrote: > > On Mon, Jan 12, 2015 at 5:11 PM, M Hickman <[email protected] > <javascript:>> wrote: > >> Obviously that's the alternative. > >> > >> I'm hoping someone else here has a copy they can make available to me. > I'd > >> prefer to spend minutes on this rather than hours. > > > > Based on the number of users who asked me, it's already been weeks. > > > > It would be faster for you ros guys to build your own based of the > > framework we use for all the images. > > Here you go when you give up searching, probally take you 30-45 mins > to generate everything: > > > https://github.com/RobertCNelson/omap-image-builder/commit/c54b1925d20c2e9bc46a62751ef9b58f139cac29 > > > git clone https://github.com/RobertCNelson/omap-image-builder > cd omap-image-builder > > ./RootStock-NG.sh -c ros_hydro > > Then from deploy: > > sudo ./setup_sdcard.sh --img-4gb BBB-eMMC-flasher --dtb beaglebone > --bbb-flasher --bbb-old-bootloader-in-emmc > > Regards, > > -- > Robert Nelson > http://www.rcn-ee.com/ > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
