> No voltage can be applied to any pin when the board is not powered. > This is a *very* difficult condition to satisfy in any sort of real world application. If you're using the Beaglebone to measure and/or monitor something it's almost certain that the 'something' will be there and turned on whether or not the Beaglebone is turned on.
OK, there are ways of doing it, but it's not easy. Even if inputs are clamped in some way, some voltage will almost certainly appear on the BBB inputs. So, what does 'No voltage' mean? If it really means zero volts then it really is impossible. Is there not be some (low) voltage that the inputs will tolerate even when the Beaglebone isn't powered up? Most chip specs tend to specify about 0.5 volts above and below the supply voltage so this would mean + or - 0.5 volts from zero when the Beaglebone isn't powered. -- Chris Green ยท -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
