Thanks kern , let me read On Wed, Nov 14, 2018 at 1:21 PM Kern Sibbald <k...@sibbald.com> wrote:
> Hello, > > I believe the manual talks about this. However, if you read the > whitepaper at: > > www.bacula.org -> Documentation -> White Papers -> Disk Backup Design > (especially chapter 3) > > or > > www.bacula.org -> Documentation -> White Papers -> Best Practices for > Disk Backup > > Most of the principles for doing multiple simultaneous jobs on multiple > devices will apply to tape drives as well as disks. > > While there are some important differences between disks and tapes, the > configurations for doing multiple simultaneous backups to multiple devices > are the same. > > Best regards, > Kern > > On 11/14/18 9:31 AM, Zeeshan Ali Shah wrote: > > Dear All, > I have ML6000 with 10 Tape Drives . > > We configure the above 10 drives as devices and added tapes in one pool > with individual volumes . each vol is one tape.. uisng label > barecode commnad > > now when we run backup . we see that autochanger only use Single Drive . > > is it possible > 1) for single job to load all of tape drives for single Job so that data > written in parallel ? > 2) for multuple jobs to load more than one drives .. > > I have set allready Max Conc jobs parameter .. but still only single drive > is used . > > > any idea plz ? > > > Zee > > > > > _______________________________________________ > Bacula-users mailing > listBacula-users@lists.sourceforge.nethttps://lists.sourceforge.net/lists/listinfo/bacula-users > > >
_______________________________________________ Bacula-users mailing list Bacula-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/bacula-users
