Re: [Bacula-users] Multiple Tape Drives all at once

[Kern Sibbald]

Hello, I believe the manual talks about this.  However, if you read the whitepaper at:  www.bacula.org -> Documentation -> White Papers -> Disk Backup Design  (especially chapter 3) or www.bacula.org -> Documentation -> White Papers -> Best Practices for Disk Backup Most of the principles for doing multiple simultaneous jobs on multiple devices will apply to tape drives as well as disks. While there are some important differences between disks and tapes, the configurations for doing multiple simultaneous backups to multiple devices are the same. Best regards, Kern On 11/14/18 9:31 AM, Zeeshan Ali Shah wrote: Dear All,  I have ML6000 with 10 Tape Drives . We configure the above 10 drives as devices and added tapes in one pool with individual volumes . each vol is one tape.. uisng label barecode commnad now when we run backup . we see that autochanger only use Single Drive .  is it possible  1) for single job to load all of tape drives for single Job so that data written in parallel ? 2) for multuple jobs to load more than one drives .. I have set allready Max Conc jobs parameter .. but still only single drive is used . any idea plz ? Zee _______________________________________________ Bacula-users mailing list Bacula-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/bacula-users

_______________________________________________
Bacula-users mailing list
Bacula-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/bacula-users