On 4/13/2011 4:48 AM, Steffen Fritz wrote: > Hey folks, > > > something strange is happening within my bacula configuration. Every help is > much appreciated! > > 1. This is, what bconsole--> status tells me about my tape drive. No pool? > > Device "Drive-1" (/dev/nst0) is mounted with: > Volume: sonntag > Pool: *unknown* > Media type: LTO-4 > Drive 0 status unknown. > Total Bytes Read=0 Blocks Read=0 Bytes/block=0 > Positioned at File=0 Block=0 > ==== > > Used Volume status: > sonntag on device "Drive-1" (/dev/nst0) > Reader=0 writers=0 devres=0 volinuse=0 If you are using a bacula earlier than 5.0.3 (I believe), then if there is a tape change during a backup, this can happen--when I've seen this issue, the tape was actually in a pool, it was (mostly) a display issue--however, it manifested that subsequent jobs couldn't start due to this, until the running job (that triggered the tape change) finished. In 5.0.3, I've heard some confirmation that this issue has been fixed--certainly I haven't seen the issue myself since switching to 5.0.3, but I never saw it very often earlier--so my datapoints are incomplete.
-se ------------------------------------------------------------------------------ Forrester Wave Report - Recovery time is now measured in hours and minutes not days. Key insights are discussed in the 2010 Forrester Wave Report as part of an in-depth evaluation of disaster recovery service providers. Forrester found the best-in-class provider in terms of services and vision. Read this report now! http://p.sf.net/sfu/ibm-webcastpromo _______________________________________________ Bacula-users mailing list Bacula-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/bacula-users
