On Mon, Mar 3, 2008 at 5:12 PM, Mark Nienberg <[EMAIL PROTECTED]> wrote: > I'm seeing this happen more often: > > 3304 Issuing autochanger "load slot 2, drive 0" command. > 3305 Autochanger "load slot 2, drive 0", status is OK. > 3301 Issuing autochanger "loaded? drive 0" command. > 3302 Autochanger "loaded? drive 0", result is Slot 2. > block.c:995 Read error on fd=6 at file:blk 0:0 on device "VXA3drive" > (/dev/nst0). > ERR=Input/output error. > block.c:995 Read error on fd=6 at file:blk 0:0 on device "VXA3drive" > (/dev/nst0). > ERR=Input/output error. > 3902 Cannot mount Volume on Storage Device "VXA3drive" (/dev/nst0) because: > Requested Volume "" on "VXA3drive" (/dev/nst0) is not a Bacula labeled > Volume, > because: ERR=block.c:995 Read error on fd=6 at file:blk 0:0 on device > "VXA3drive" > (/dev/nst0). ERR=Input/output error. > 3905 Device "VXA3drive" (/dev/nst0) open but no Bacula volume is mounted. > If this is not a blank tape, try unmounting and remounting the Volume. > > So then I unmount and remount the volume (which means it is unloaded and > reloaded by > the changer) and it works. > > Bacula 2.2.6 with a VXA320 drive and packetloader changer. > > The tapes (yes it happens on multiple tapes) are relatively new and the > drive has > just been cleaned. > > Any suggestions for troubleshooting? >
Have you tried adding a delay in your mtxchanger script where it says it might be needed? John ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Bacula-users mailing list Bacula-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/bacula-users
