I'm seeing this happen more often: 3304 Issuing autochanger "load slot 2, drive 0" command. 3305 Autochanger "load slot 2, drive 0", status is OK. 3301 Issuing autochanger "loaded? drive 0" command. 3302 Autochanger "loaded? drive 0", result is Slot 2. block.c:995 Read error on fd=6 at file:blk 0:0 on device "VXA3drive" (/dev/nst0). ERR=Input/output error. block.c:995 Read error on fd=6 at file:blk 0:0 on device "VXA3drive" (/dev/nst0). ERR=Input/output error. 3902 Cannot mount Volume on Storage Device "VXA3drive" (/dev/nst0) because: Requested Volume "" on "VXA3drive" (/dev/nst0) is not a Bacula labeled Volume, because: ERR=block.c:995 Read error on fd=6 at file:blk 0:0 on device "VXA3drive" (/dev/nst0). ERR=Input/output error. 3905 Device "VXA3drive" (/dev/nst0) open but no Bacula volume is mounted. If this is not a blank tape, try unmounting and remounting the Volume.
So then I unmount and remount the volume (which means it is unloaded and reloaded by the changer) and it works. Bacula 2.2.6 with a VXA320 drive and packetloader changer. The tapes (yes it happens on multiple tapes) are relatively new and the drive has just been cleaned. Any suggestions for troubleshooting? Thanks, Mark ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Bacula-users mailing list Bacula-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/bacula-users
