I only have two pools - Default and Scratch. I have tried on both, neither
work. Same issue.
-----Original Message-----
From: Ralf Gross [mailto:[EMAIL PROTECTED]
Sent: Monday, February 25, 2008 11:28 PM
To: bacula-users@lists.sourceforge.net
Subject: Re: [Bacula-users] bacula tape drive can test but not use for
job s
Justin Francesconi schrieb:
> Well, it turns out there was an issue with the bacula-dir.conf as stated.
> It works fine and btape can mostly control the drive, except for every
time
> I try to run a backup job to the tape, I get the following error:
> Cannot find any appendable volumes.
> Please use the "label" command to create a new Volume for:
>
> I have used both ./bconsole and ./btape to 'label' the tape. Each time I
> label it, it says it was successful. I have tried to rewind the tape,
move
> the tape to the end of the medium, everything I can think of, and it keeps
> giving that same error. What am I missing here?
Did you put the tape into the right pool?
Ralf
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Bacula-users mailing list
Bacula-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/bacula-users
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Bacula-users mailing list
Bacula-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/bacula-users
