On Friday 04 January 2002 02:17 am, Daniel Cota wrote: > After six hours of trying to get this stuff working, I've decided to post a > message here. > > dmesg shows that I have the following error: > ALSA card-via686a.c:1191: VIA 82C686A soundcard not found or device busy > > Anyone help would be greatly appreciated, as I'm quite stuck. > > System info follows below. > > Thanks... > Daniel > > > BIOS has: > AC97 support enabled, > Legacy support enabled, > Soundblaster emulation disabled. > > Relevant kernel configuration parameters: > CONFIG_SOUND=y > # CONFIG_SOUND_VIA82CXXX is not set > > Relevant /etc/modules.conf: > # ALSA native device support > alias char-major-116 snd > options snd snd_major=116 snd_cards_limit=1 > alias snd-card-0 snd-card-via686a > > # OSS-free setup > alias char-major-14 soundcore > alias sound-slot-0 snd-card-0 > > modprobe -v snd-card-via686a yields: > > /sbin/insmod /lib/modules/2.4.17/misc/snd-ac97-codec.o > Using /lib/modules/2.4.17/misc/snd-ac97-codec.o > Symbol version prefix '' > /sbin/insmod /lib/modules/2.4.17/misc/snd-seq-device.o > Using /lib/modules/2.4.17/misc/snd-seq-device.o > /sbin/insmod /lib/modules/2.4.17/misc/snd-rawmidi.o > Using /lib/modules/2.4.17/misc/snd-rawmidi.o > /sbin/insmod /lib/modules/2.4.17/misc/snd-mpu401-uart.o > Using /lib/modules/2.4.17/misc/snd-mpu401-uart.o > /sbin/insmod /lib/modules/2.4.17/misc/snd-timer.o > Using /lib/modules/2.4.17/misc/snd-timer.o > /sbin/insmod /lib/modules/2.4.17/misc/snd-pcm.o > Using /lib/modules/2.4.17/misc/snd-pcm.o > /sbin/insmod /lib/modules/2.4.17/misc/snd-card-via686a.o > Using /lib/modules/2.4.17/misc/snd-card-via686a.o > /lib/modules/2.4.17/misc/snd-card-via686a.o: init_module: No such device > Hint: insmod errors can be caused by incorrect module parameters, including > invalid IO or IRQ parameters > /lib/modules/2.4.17/misc/snd-card-via686a.o: insmod > /lib/modules/2.4.17/misc/snd-card-via686a.o failed > # delete snd-pcm > # delete snd-timer > # delete snd-mpu401-uart > # delete snd-rawmidi > # delete snd-seq-device > # delete snd-ac97-codec > /lib/modules/2.4.17/misc/snd-card-via686a.o: insmod snd-card-via686a failed > > dmesg gives: > > Linux version 2.4.17 ([EMAIL PROTECTED]) (gcc version 2.96 > 20000731 (Mandrake Linux 8.1 2.96-0.62mdk)) #2 Thu Jan 3 18:14:55 PST 2002 > BIOS-provided physical RAM map: > BIOS-e820: 0000000000000000 - 000000000009fc00 (usable) > BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved) > BIOS-e820: 00000000000ec000 - 0000000000100000 (reserved) > BIOS-e820: 0000000000100000 - 0000000007ff0000 (usable) > BIOS-e820: 0000000007ff0000 - 0000000007ff8000 (ACPI data) > BIOS-e820: 0000000007ff8000 - 0000000008000000 (ACPI NVS) > BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved) > On node 0 totalpages: 32752 > zone(0): 4096 pages. > zone(1): 28656 pages. > zone(2): 0 pages. > Kernel command line: auto BOOT_IMAGE=linux ro root=305 devfs=mount > Initializing CPU#0 > Detected 801.850 MHz processor. > Console: colour VGA+ 80x25 > Calibrating delay loop... 1599.07 BogoMIPS > Memory: 126956k/131008k available (940k kernel code, 3664k reserved, 264k > data, 192k init, 0k highmem) > Dentry-cache hash table entries: 16384 (order: 5, 131072 bytes) > Inode-cache hash table entries: 8192 (order: 4, 65536 bytes) > Mount-cache hash table entries: 2048 (order: 2, 16384 bytes) > Buffer-cache hash table entries: 4096 (order: 2, 16384 bytes) > Page-cache hash table entries: 32768 (order: 5, 131072 bytes) > CPU: Before vendor init, caps: 0183f9ff c1c3f9ff 00000000, vendor = 2 > CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (64 bytes/line) > CPU: L2 Cache: 512K (64 bytes/line) > CPU: After vendor init, caps: 0183f9ff c1c3f9ff 00000000 00000000 > Intel machine check architecture supported. > Intel machine check reporting enabled on CPU#0. > CPU: After generic, caps: 0183f9ff c1c3f9ff 00000000 00000000 > CPU: Common caps: 0183f9ff c1c3f9ff 00000000 00000000 > CPU: AMD Athlon(tm) Processor stepping 01 > Enabling fast FPU save and restore... done. > Checking 'hlt' instruction... OK. > POSIX conformance testing by UNIFIX > mtrr: v1.40 (20010327) Richard Gooch ([EMAIL PROTECTED]) > mtrr: detected mtrr type: Intel > PCI: PCI BIOS revision 2.10 entry at 0xfdb71, last bus=1 > PCI: Using configuration type 1 > PCI: Probing PCI hardware > PCI: Using IRQ router VIA [1106/0686] at 00:07.0 > Linux NET4.0 for Linux 2.4 > Based upon Swansea University Computer Society NET3.039 > Initializing RT netlink socket > apm: BIOS version 1.2 Flags 0x03 (Driver version 1.15) > Starting kswapd > pty: 256 Unix98 ptys configured > Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ > SERIAL_PCI enabled > ttyS00 at 0x03f8 (irq = 4) is a 16550A > ttyS01 at 0x02f8 (irq = 3) is a 16550A > block: 128 slots per queue, batch=32 > Uniform Multi-Platform E-IDE driver Revision: 6.31 > ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx > VP_IDE: IDE controller on PCI bus 00 dev 39 > VP_IDE: chipset revision 16 > VP_IDE: not 100% native mode: will probe irqs later > ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx > VP_IDE: VIA vt82c686a (rev 22) IDE UDMA66 controller on pci00:07.1 > ide0: BM-DMA at 0xffa0-0xffa7, BIOS settings: hda:DMA, hdb:pio > ide1: BM-DMA at 0xffa8-0xffaf, BIOS settings: hdc:DMA, hdd:pio > hda: WDC WD102BB, ATA DISK drive > hdc: ATAPI 52X CDROM, ATAPI CD/DVD-ROM drive > ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 > ide1 at 0x170-0x177,0x376 on irq 15 > hda: 20028960 sectors (10255 MB) w/2048KiB Cache, CHS=1246/255/63, UDMA(33) > hdc: ATAPI 48X CD-ROM drive, 128kB Cache, UDMA(33) > Uniform CD-ROM driver Revision: 3.12 > Partition check: > hda: hda1 hda2 < hda5 hda6 > > FDC 0 is a post-1991 82077 > Linux Tulip driver version 0.9.15-pre9 (Nov 6, 2001) > PCI: Found IRQ 9 for device 00:0f.0 > PCI: Sharing IRQ 9 with 00:07.3 > PCI: Sharing IRQ 9 with 00:07.2 > tulip0: MII transceiver #1 config 3100 status 7829 advertising 01e1. > eth0: Lite-On 82c168 PNIC rev 32 at 0xc400, 00:C0:F0:5B:7A:9F, IRQ 9. > Linux agpgart interface v0.99 (c) Jeff Hartmann > agpgart: Maximum main memory to use for agp memory: 94M > agpgart: Detected Via Apollo Pro KX133 chipset > agpgart: AGP aperture is 64M @ 0xe0000000 > Via 686a audio driver 1.9.1 > PCI: Found IRQ 10 for device 00:07.5 > ac97_codec: AC97 Audio codec, id: 0x4144:0x5348 (Analog Devices AD1881A) > via82cxxx: board #1 at 0xD800, IRQ 10 > usb.c: registered new driver hub > usb.c: registered new driver hid > hid-core.c: v1.8 Andreas Gal, Vojtech Pavlik <[EMAIL PROTECTED]> > hid-core.c: USB HID support drivers > usb.c: registered new driver wacom > wacom.c: v1.21:USB Wacom Graphire and Wacom Intuos tablet driver > NET4: Linux TCP/IP 1.0 for NET4.0 > IP Protocols: ICMP, UDP, TCP, IGMP > IP: routing cache hash table of 512 buckets, 4Kbytes > TCP: Hash tables configured (established 8192 bind 8192) > NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. > VFS: Mounted root (ext2 filesystem) readonly. > Freeing unused kernel memory: 192k freed > Adding Swap: 401584k swap-space (priority -1) > EXT2-fs warning: maximal mount count reached, running e2fsck is recommended > usb-uhci.c: $Revision: 1.268 $ time 00:29:57 Jan 4 2002 > usb-uhci.c: High bandwidth mode enabled > PCI: Found IRQ 9 for device 00:07.3 > PCI: Sharing IRQ 9 with 00:07.2 > PCI: Sharing IRQ 9 with 00:0f.0 > usb-uhci.c: USB UHCI at I/O 0xcc00, IRQ 9 > usb-uhci.c: Detected 2 ports > usb.c: new USB bus registered, assigned bus number 1 > hub.c: USB hub found > hub.c: 2 ports detected > PCI: Found IRQ 9 for device 00:07.2 > PCI: Sharing IRQ 9 with 00:07.3 > PCI: Sharing IRQ 9 with 00:0f.0 > usb-uhci.c: USB UHCI at I/O 0xc800, IRQ 9 > usb-uhci.c: Detected 2 ports > usb.c: new USB bus registered, assigned bus number 2 > hub.c: USB hub found > hub.c: 2 ports detected > usb-uhci.c: v1.268:USB Universal Host Controller Interface driver > hub.c: USB new device connect on bus2/2, assigned device number 2 > input0: Wacom Graphire on usb2:2.0 > eth0: Setting full-duplex based on MII#1 link partner capability of 45e1. > [drm] Initialized tdfx 1.0.0 20010216 on minor 0 > ALSA card-via686a.c:1191: VIA 82C686A soundcard not found or device busy > ALSA card-via686a.c:1191: VIA 82C686A soundcard not found or device busy > ALSA card-via686a.c:1191: VIA 82C686A soundcard not found or device busy > ALSA card-via686a.c:1191: VIA 82C686A soundcard not found or device busy > ALSA card-via686a.c:1191: VIA 82C686A soundcard not found or device busy
_______________________________________________ Alsa-user mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/alsa-user
