The issue for me is mobilization and setup for that machine. I will not move it for a 1k foot job unless I am getting $10K. I can do 10K on good plowing just about as easy as 1K due to mobilization and setup.
But 10K feet for $70K would be the preferred job. From: Josh Luthman Sent: Friday, December 23, 2022 10:18 AM To: Chuck McCown Cc: AnimalFarm Microwave Users Group Subject: Re: [AFMUG] HDD per foot cost Well would you rather do 10k feet in a day for $10k or 1k feet in a day for $7k? On Fri, Dec 23, 2022 at 10:47 AM Chuck McCown <[email protected]> wrote: My plow cost me $125K used and takes a semi to move. You will not get the plow, fuel, operator and mobilization for $1/foot unless it is 1M feet through Nebraska sod with no stops. From: Josh Luthman Sent: Friday, December 23, 2022 6:11 AM To: AnimalFarm Microwave Users Group Cc: Chuck McCown Subject: Re: [AFMUG] HDD per foot cost $2.25 for plowing here, should be $1 if you ask me. On Thu, Dec 22, 2022 at 3:39 PM Chuck McCown via AF <[email protected]> wrote: I wish I could get that for plowing. Normally it is in the $4.50 range assuming wide open range. I have seen it as low as $1.50. From: [email protected] Sent: Thursday, December 22, 2022 1:33 PM To: 'AnimalFarm Microwave Users Group' Subject: Re: [AFMUG] HDD per foot cost The highest I saw was $50/ft. $6-8 sounds like plowing prices. I’d expect at least $15/ft for HDD. Whoever’s doing it for $6-8/ft don’t lose that guy’s number. From: AF <[email protected]> On Behalf Of Jim Bouse [Brazos WiFi] Sent: Thursday, December 22, 2022 10:27 AM To: AnimalFarm Microwave Users Group <[email protected]> Subject: Re: [AFMUG] HDD per foot cost That varies greatly. Somewhere between $6-8/ft here in central Texas rural roads and rural subdivisions. Anywhere with more obstructions will cost significantly more due to the effort to avoid other utilities. Jim Bouse Owner - Brazos WiFi 979-999-7000 http://www.brazoswifi.com From: AF <[email protected]> On Behalf Of Carl Peterson Sent: Thursday, December 22, 2022 9:24 AM To: AnimalFarm Microwave Users Group <[email protected]> Subject: [AFMUG] HDD per foot cost What is the going rate per foot for HDD drilling and pullback of two SDR11 ducts and a trace wire? Very sandy soil in the FL panhandle. All materials provided? Around 4-5K' split into three or four runs. -- Carl Peterson PORT NETWORKS 401 E Pratt St, Ste 2553 Baltimore, MD 21202 (410) 637-3707 ---------------------------------------------------------------------------- -- AF mailing list [email protected] http://af.afmug.com/mailman/listinfo/af_af.afmug.com -- AF mailing list [email protected] http://af.afmug.com/mailman/listinfo/af_af.afmug.com
-- AF mailing list [email protected] http://af.afmug.com/mailman/listinfo/af_af.afmug.com
