No it won't fit, you would need to solder a #22-24 wire to the cladding and then the connector will take the drain wire you soldered on the side esd crimp lug
On Tue, May 25, 2021, 10:51 PM Steve Jones <thatoneguyst...@gmail.com> wrote: > we use a lot of bbdge, of you have an ezrj45 design that takes that > without breaking the housing over time, youre a god. its the copper clad > cable, not foil and drain > > > On Wed, May 26, 2021 at 12:44 AM TJ Trout <t...@voltbb.com> wrote: > >> do you use ezrj45? I can send you some that make shielded terminations >> super simple, send me your addy offlist >> >> On Tue, May 25, 2021 at 9:28 PM Steve Jones <thatoneguyst...@gmail.com> >> wrote: >> >>> is this a protected component? or is it acceptable for scumbags like me >>> to just bond the shield and use regular RJ45?. >>> -- >>> AF mailing list >>> AF@af.afmug.com >>> http://af.afmug.com/mailman/listinfo/af_af.afmug.com >>> >> -- >> AF mailing list >> AF@af.afmug.com >> http://af.afmug.com/mailman/listinfo/af_af.afmug.com >> > -- > AF mailing list > AF@af.afmug.com > http://af.afmug.com/mailman/listinfo/af_af.afmug.com >
-- AF mailing list AF@af.afmug.com http://af.afmug.com/mailman/listinfo/af_af.afmug.com
