I don't have a 450m....
Can you have both ports on with different IP's? Even if they're not
bridged at least a way to back door in through the second port?
On 4/22/2021 12:07 PM, Nate Burke wrote:
Oh, that's bad. A fully functional AP, hanging in the air, that's
completely unusable just because what should/can be redundant, isn't,
because of software.
On 4/22/2021 10:58 AM, Josh Luthman wrote:
It sucks. That's how it is.
If it's 5 GHz you can do it over RF. If it's 3 GHz you can't because
it'll have to reach a SAS to transmit.
Josh Luthman
24/7 Help Desk: 937-552-2340
Direct: 937-552-2343
1100 Wayne St
Suite 1337
Troy, OH 45373
On Thu, Apr 22, 2021 at 11:14 AM Nate Burke <n...@blastcomm.com
<mailto:n...@blastcomm.com>> wrote:
I'm getting ready to deploy my first set of 450M radios, from my
bench
testing, and reading through the manual, do you have to Choose which
data path is active, Copper OR Fiber? And the only way to switch
it if
that path is down is to log into the Radio with an SM connection
over
the RF? That can't be right can it?
The EPMP radios bridge the copper and Fiber inside the radio so
both are
active. That doesn't seem to be the case with the 450M. Does the
450M
only allow one data path, and if it breaks your SOL unless you
can gain
sudo-physical access to the AP? I have be missing where you set the
primary/secondary data path, but I haven't been able to find it yet.
--
AF mailing list
AF@af.afmug.com <mailto:AF@af.afmug.com>
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
<http://af.afmug.com/mailman/listinfo/af_af.afmug.com>
--
AF mailing list
AF@af.afmug.com
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
