Yeah, it just would not tighten down enough without a ton of force. On Tue, Oct 27, 2020 at 2:10 PM Nate Burke <n...@blastcomm.com> wrote:
> Did you remember to put on the 'Teeth' part of the mount that is opposite > the UBolt? > > On 10/27/2020 2:01 PM, Nate Burke wrote: > > Yes. Mount sucks. Didn't have that problem though. We installed them on > a flat roof. The installer had to tell me to stop walking around on the > other end of the roof because that was causing signal to have 10db swings. > > Was your pipe too small? > > On 10/27/2020 1:28 PM, Jason McKemie wrote: > > Has anyone deployed these? > > I tried to set up a link and it seems like something is wrong with the > mount. I can get it tightened down so it will not move horizontally, > however to get it to not move vertically a very excessive amount of force > is necessary. So much so that I actually crushed the threads on the u-bolt > and had to take it off with a breaker bar. Ubiquiti support has been about > as helpful as not having asked in the first place. > > -Jason > > > > > > > -- > AF mailing list > AF@af.afmug.com > http://af.afmug.com/mailman/listinfo/af_af.afmug.com >
-- AF mailing list AF@af.afmug.com http://af.afmug.com/mailman/listinfo/af_af.afmug.com
