Your maximum power levels should be set to the levels for each modulation step that are listed on the attached Adaptive Modulation Data Sheet. In the example below, the coordinator has used the ATPC “coordinated power” advantage to clear interference into another user. The “coordinated power” whenever listed with a nominal and maximum level is not a user setting and is instead a level calculated by the coordinator using the methodology from TIA TSB10-F and NSMA recommendation WG18.91.032.
So, set your max powers to the levels listed on the ACM data sheet, turn on ATPC, and you’re good to go. > On Sep 10, 2020, at 6:33 AM, Matt Hoppes <mattli...@rivervalleyinternet.net> > wrote: > > Yes. You need to be able to set your maximum power at each modulation level. > >> On Sep 10, 2020, at 12:00 AM, Steve Jones <thatoneguyst...@gmail.com> wrote: >> >> >> So when I see the following, I use the "coordinated" power from this section >> to set maximum ATPC power, 26 in this case >> >> Nominal Coordinated Maximum >> Power (dBm) 15.0 26.0 29.0 >> Received Level (dBm) -42.4 -31.4 -28.4 >> EIRP (dBm) 63.7 63.7 >> >> But the Adaptive modulation sheet shows coordinated power all the way up to >> 29 >> >> Am I missing out on 3dBm I could be using during fade? >> >> >> -- >> AF mailing list >> AF@af.afmug.com >> http://af.afmug.com/mailman/listinfo/af_af.afmug.com > -- > AF mailing list > AF@af.afmug.com > http://af.afmug.com/mailman/listinfo/af_af.afmug.com
-- AF mailing list AF@af.afmug.com http://af.afmug.com/mailman/listinfo/af_af.afmug.com
