If there’s double the bandwidth or more in frequency separation between T-R
at the bucking site you should be okay.  It will just be difficult to add
frequencies / new paths at that site in the future.  Send me the path data
and I’ll take a quick look.

On Fri, Mar 13, 2020 at 9:00 PM Ken Hohhof <af...@kwisp.com> wrote:

> I realize we forced them into this situation by wanting new links
> involving 2 sites where we already have 11 GHz.
>
>
>
> One of the sites is a water tank where it might be possible to put the
> tank between the 2 dishes, but that is not the bucking site.  That site is
> actually I think a Rohn 45 and the antennas would be close to each other,
> although not the same azimuth.
>
>
>
> It sounds like I should ask them to look at it again with one of the
> shorter links in 18 GHz.
>
>
>
> *From:* AF <af-boun...@af.afmug.com> *On Behalf Of *Tim Hardy
> *Sent:* Friday, March 13, 2020 7:38 PM
> *To:* AnimalFarm Microwave Users Group <af@af.afmug.com>
> *Subject:* Re: [AFMUG] licensed link high/low question
>
>
>
> The radios certainly don’t have any isolation from this type of
> interference, so what you’re relying on is totally on the antennas -
> there’s not much FSL on these and I wouldn’t bet my life on a 2’ Category B
> to provide the kind of close-coupling loss needed on a co-located system.
> AT&T and MCI used to do it when they had completely back-to-back horns or
> ultra-high performance antennas but they provide about 80 dB of
> discrimination front-to-back.
>
> Sent from my iPad
>
>
>
> On Mar 13, 2020, at 8:31 PM, Colin Stanners <cstann...@gmail.com> wrote:
>
> 
>
> To my knowledge the radios and dishes have enough isolation that H/L match
> at a site is not necessary unless you're almost pointing in the
> same direction with those dishes (or have a TX frequency at one site
> overlapping a RX) . The opposite polarity increases the isolation so you
> have even less worry in this case. That H/L match idea is more of a
> tendency and to simplify planning than a rule.
>
> On Fri, Mar 13, 2020, 6:52 PM Ken Hohhof, <af...@kwisp.com> wrote:
>
> I am having some 11 GHz links coordinated and the draft PCNs they sent me
> have one site high on one link and low on the other link.  They are however
> different sub bands, and one is HPOL and the other is VPOL.  Does this make
> it OK?  I could probably do one of the links in 18 GHz.
>
>
>
> I had internalized the idea that you never had high and low at the same
> site.
>
> --
> AF mailing list
> AF@af.afmug.com
> http://af.afmug.com/mailman/listinfo/af_af.afmug.com
>
> --
> AF mailing list
> AF@af.afmug.com
> http://af.afmug.com/mailman/listinfo/af_af.afmug.com
>
> --
> AF mailing list
> AF@af.afmug.com
> http://af.afmug.com/mailman/listinfo/af_af.afmug.com
>
-- 
AF mailing list
AF@af.afmug.com
http://af.afmug.com/mailman/listinfo/af_af.afmug.com

Reply via email to