Greetings,
You don't say for sure, but I presume the same model of tape
drives are in use in both tape libraries, LTO3 for example.
1) Delete the old Library from TSM. To do this, delete the:
- drive paths
- drives
- library path
- library
In that order.
When you do this, the old library inventory is deleted.
2) Pause the new library. Use the touchscreen on the library to do
this.
3) Open the doors, and put the tapes into the new library. When you
close the doors, wait until the library gets to Ready status.
4) Using the Web site provided for the library, or the touchscreen on
the front of the library, perform a full inventory of the library.
5) Check the new tapes into the new library using TSM admin commands:
checkin libv ibm3584 search=yes checkl=barc status=scratch
checkin libv ibm3584 search=yes checkl=barc status=private
(assuming "ibm3584" is your library name)
6) Issue "q actlog" to monitor the progress of these, and wait until
complete. A "q libv" should show the tapes now in the new library.
7) Use the "update devclass" command to update the device class for the
device classes that pointed to your old library so the now point to your
new library.
I don't think I have left anything out.
Best Regards,
John D. Schneider
Phone: 314-364-3150
Cell: 314-486-2359
Email: [EMAIL PROTECTED]
-----Original Message-----
From: ADSM: Dist Stor Manager [mailto:[EMAIL PROTECTED] On Behalf Of
Hemi
Sent: Saturday, July 12, 2008 1:28 PM
To: ADSM-L@VM.MARIST.EDU
Subject: [ADSM-L] New Tape Library
Hi All ,
Im new to this forum ..I have similar kind of situation where we had to
replace DELL libraries with IBM 3584ATL to windows HOST.My onsite person
had pluged OFF the old library .... And Plugged in the new library
(3584ATL) ... And device driver for 3584atl has been overwritten the
previous DELL library ...We are able to configure the new library and
drives of the new one ...and backups are migrating to tapes of
3584atl...but we have a problem moving the tapes from old library to new
library in TSM level ...
It shows in private status with last_use as NULL for few tapes which are
already checked out ...
For other tapes which are not checked out from libv with old library ...
Shows 2 entries in the libvol
..
my question is ..how to checkin the used tapes of old library to new
one , and same data need to be accessed by the new libr when the old
library is fully plugged off..
+----------------------------------------------------------------------
|This was sent by [EMAIL PROTECTED] via Backup Central.
|Forward SPAM to [EMAIL PROTECTED]
+----------------------------------------------------------------------
This e-mail contains information which (a) may be PROPRIETARY IN NATURE OR
OTHERWISE PROTECTED BY LAW FROM DISCLOSURE, and (b) is intended only for the
use of the addressee(s) named above. If you are not the addressee, or the
person responsible for delivering this to the addressee(s), you are notified
that reading, copying or distributing this e-mail is prohibited. If you have
received this e-mail in error, please contact the sender immediately.
