Wanda, I have 5550 and it works fine for me. Just to be sure I reset the address and then reentered it. I then sent a test trap and got it on my management console right away.
Perhaps Rick is right; you might have a partial load of the FW. Mahesh >>> [EMAIL PROTECTED] 3/2/2006 5:28:26 PM >>> Wanda, The current library code is 5770. I would install this code level and then call IBM if the problem is still present. I have seen strange things like this when a firmware load doesn't complete. Even though you said this is a new unit, the factory firmware load might have been incomplete. ftp://service.boulder.ibm.com/storage/358x/3584/ Rick Saylor Austin community College At 03:39 PM 3/2/2006, you wrote: >Well, this is peculiar. > >This is a new 3584, firmware level is 5550. (Thanks to the folks who >helped me figure that out yesterday!) > >When I use the Tape Library Specialist (web interface) to set the SNMP >destination address, the Tape Library Specialist crashes. >That is, the web interface goes to "page not found", and won't >reconnect. > >When I go to the LED and look at Network Settings under Ethernet, it >says "Ethernet is not installed in this frame", which is of course not >true. >After a reboot, the Ethernet network settings reappear just as they were >before. > >This appears to me to clearly be a problem with the Tape Library >Specialist. > > >1) Is the level of the Tape Library Specialist considered to be the same >as the firmware level - 5550? > >2) Where does one research problems with the Tape Library Specialist to >see if the problem has been reported? ---------------------------------------------------------------------------- Rick Saylor Austin Community College Voice: (512)223-1182 Director of System Services 9101 Tuscany Way Fax: (512)223-1211 Information Technology Austin, Texas 78754
