Thank you very much for your information, I'll do it this way.
Kind regards
Werner Nussbaumer
-----Original Message-----
From: Phillip.Ford [mailto:[EMAIL PROTECTED]]
Sent: Freitag, 11. August 2000 17:34
To: Phillip.Ford; ADSM-L
Subject: Re: BACKUP STGPOOL and BACKUP DB Question
I can not say what is best but what we do.
1) backup diskpool to DLTPOOL2
2) Migrate
3) backup the tape pool to DLTPOOL2
4) Backup DB
Both backups must be to the same copy tape pool.
We do it in this order to keep down tape to tape operations. If no backups
occur during step 1 or 2 then step 3 is do nothing. If they do occur then
only the new data has to go tape to tape to be backed up.
Hope this helps
--
Phillip Ford
Senior Software Specialist
Corporate Computer Center
Schering-Plough Corp.
(901) 320-4462
(901) 320-4856 FAX
[EMAIL PROTECTED]
-----Original Message-----
From: Werner Nussbaumer [mailto:[EMAIL PROTECTED]]
Sent: Friday, August 11, 2000 9:20 AM
To: [EMAIL PROTECTED]
Subject: BACKUP STGPOOL and BACKUP DB Question
Hello All
I set up a storage pool DISKPOOL, a tape pool DLTPOOL1 (4 tapes) and a
copypool
DLTPOOL2 (4 tapes).
DISKPOOL is migrated to the next pool DLTPOOL1. After that I would do a
BACKUP STGPOOL DISKPOOL1 DLTPOOL2
and
BACKUP STGPOOL DLTPOOL1 DLTPOOL2
and finally
BACKUP DB DEVCLASS=DLTCLASS1 SCRATCH=NO TYPE=FULL VOLUMENAMES=TAPE1,TAPE2
BACKUP DB DEVCLASS=DLTCLASS2 SCRATCH=NO TYPE=FULL
VOLUMENAMES=TAPE101,TAPE102
What is the best scenario to
1) Migrate
2) backup the diskpool
3) backup the tape pool
4) Backup DB
5) Create a second backup of the DB?
Thanks for any information
Regards
Werner Nussbaumer
