I just booted without any "ether0=" and "pcmcia0=" lines and the problem persists.
Only change is that on boot I see "rtl8139: port 0x400 in use" only once and not two times as I mentioned in my previous message. Best regards, F. Caulier On 12/31/09, erik quanstrom <quans...@coraid.com> wrote: >> > ether0=rtl8139 >> >> This is also wrong. You want "ether0=type=rtl8319". > > good catch. it should be "ether0=type=rtl8139" > though. one should not need this oft mis-typed > line unless > - you wish to force the a particular ordering of controller > types. say you want the rtl8139 to be the first controller > and, say, a 83815 to be the second. i use this on some machines > to force the myricom card to be eth0. > - you need to specify more information, like an ea or > an irq. > - you're using ken's fileserver. > > - erik > >
