On 03/29/10 10:31 AM, Jim wrote:
I had a drive fail and replaced it with a new drive. During the resilvering
process the new drive had write faults and was taken offline. These faults were
caused by a broken SATA cable (drive checked with Manufacturers software and
all ok). New cable fixed the the failure. However, now the drive shows as
faulted.
I know the drive is healthy so want to force a rescrub. However, this wont happen while
it is showing FAULTED. I tried to force a replace but this gives the error "Cannot
replace a replacing device". So I seem to be in a stuck state, where the replace
wont complete. Please help - screen output below.
Can you zpool clear the device?
--
Ian.
_______________________________________________
zfs-discuss mailing list
zfs-discuss@opensolaris.org
http://mail.opensolaris.org/mailman/listinfo/zfs-discuss
