On Tue, Apr 15, 2008 at 2:44 AM, Jayaraman, Bhaskar <[EMAIL PROTECTED]> wrote: > Thanks Brandon, so basically there is no way of knowing: - > 1] How your file will be distributed across the disks > 2] What will be the stripe size
You could look at the source to try to determine it. I'm not sure if there's a hard & fast rule however. The stripe size will be across all vdevs that have space. For each stripe written, more data will land on the empty vdev. Once the previously existing vdevs fill up, writes will go to the new vdev. > 3] If the blocks are redistributed when a new disk is attached to the > storage. No existing data is redistributed, so far as I know. If there is a lot of churn on the volume, it will eventually balance out, but if you add a new vdev and don't add data to the zpool, there will be no data on the new vdev. Unless you've dedicated a device, the ZIL is supposed to stripe across all vdevs, so there will be some activity on the new volume. > If you happen to know, what does "Every block is its own RAID-Z stripe, > regardless of blocksize" mean? http://blogs.sun.com/bonwick/category/ZFS In traditional RAID-5 or RAID-6, the entire stripe has to be read, altered, XOR re-calculated, and written to disk. Because of this, there's the RAID-5 write hole, where data can be lost or corrupted. By "full stripe", I don't think he meant a write across all vdevs, but a write of data and associated XOR information, which would allow recovery in the event of a device death. > 4] So if I create files 64kb or less then the I'm assuming zfs will > determine some stripe size and stripe my file across the assigned block > pointers (let's assume 4 blocks of 16kb each)??? > > 5] However if I create a file of 256kb then it may stripe it across 4 > blocks again with the stripe size at 64kb this time, but we can never be > sure how this is decided is that right? For a non-protected stripe, I don't think that's how it works. It'll write a data to some (but not necessarily all) of the vdevs. I believe the cut off is 512KB. So a write of 1MB will "stripe" across 2 vdevs (biased toward under-utilized vdevs), while 4 writes of 64KB each could land on the same vdev. I think RAID-Z is different, since the stripe needs to spread across all devices for protection. I'm not sure how it's done. > 6] Still I don't see how each block becoming its own stripe unless there > is byte level striping with each byte on a different disk block which > would be very wasteful. See above. Again, my answers may not be correct. This is what I've gleaned from my own research. -B -- Brandon High [EMAIL PROTECTED] "The good is the enemy of the best." - Nietzsche _______________________________________________ zfs-discuss mailing list zfs-discuss@opensolaris.org http://mail.opensolaris.org/mailman/listinfo/zfs-discuss
