Oops -- I transposed 1 and 2 in the last sentence. Corrected version, and hopefully a bit easier to read:
# zpool replace mypool olddisk newdisk This will do all the intermediate steps you'd expect: attach newdisk as a mirror of olddisk, resilver, detach olddisk, and grow the pool to reflect the larger size of newdisk. Jeff On Wed, Feb 27, 2008 at 05:04:02PM -0800, Jeff Bonwick wrote: > Yes. Just say this: > > # zpool replace mypool disk1 disk2 > > This will do all the intermediate steps you'd expect: attach disk2 > as a mirror of disk1, resilver, detach disk2, and grow the pool > to reflect the larger size of disk1. > > Jeff > > On Wed, Feb 27, 2008 at 04:48:59PM -0800, Bill Shannon wrote: > > I've just started using zfs. I copied data from a ufs filesystem on > > disk 1 to a zfs pool/filesystem on disk 2. Can I add disk 1 as a mirror > > for disk 2, and then remove disk 2 from the mirror, and end up with all > > the data back on disk 1 in zfs (after some amount of time, of course)? > > If disk 1 is larger than disk 2, will the larger amount of space be > > available after I remove the disk 2 mirror? > > > > (Disk 2 is a full disk, but disk 1 is actually just a partition of a > > disk. I assume that doesn't make any difference.) > > > > Thanks. > > _______________________________________________ > > zfs-discuss mailing list > > zfs-discuss@opensolaris.org > > http://mail.opensolaris.org/mailman/listinfo/zfs-discuss _______________________________________________ zfs-discuss mailing list zfs-discuss@opensolaris.org http://mail.opensolaris.org/mailman/listinfo/zfs-discuss
