On Thu, Nov 1, 2018 at 6:33 PM Erik Hoogeveen
<erik.hoogev...@outlook.com> wrote:
>
> Hello,
>
> I’m rather new to embedded software and Yocto. I hope this is the right place 
> to ask. If not I’d appreciate it if someone could point me the right way to 
> do so.
>
> I’m trying to make a Yocto build for a raspberry pi 3. I’ve got it booting 
> and doing things on a regular plain vanilla Raspberry pi 3 board. It boots 
> and over serial console I can log in and do things.
> But the ultimate target is to run this image on my own board which is built 
> around a Raspberry Pi Compute Module 3 Lite. Since regular Raspbian (what’ 
> I’ve used so far) works fine on both boards without modification I assumed 
> that this would be the case as well with this image I made myself. But it 
> turns out I was wrong.
>
> When I take the image from the build and stick it in my compute module board, 
> literally nothing happens. The boot sequence doesn’t seem to even begin, I 
> get nothing on the serial console, and none of the peripherals like the 
> ethernet ever come to life either.
>
> And since nothing happens I really have no idea where to look for a solution. 
> I’m guessing this is a bit of a noob issue? It would be great if someone 
> could point me in a direction to look at.

you probably built for a raspberrypi3 or raspberrypi3-64 ffor the 64bit

i believe the compute module 3 target is raspberrypi-cm3

you could pretty muuchh do a diff uunder the meta-raspberryypi ffor
the differences in whats built

>
> Kind regards,
> Erik Hoogeveen.
> --
> _______________________________________________
> yocto mailing list
> yocto@yoctoproject.org
> https://lists.yoctoproject.org/listinfo/yocto
-- 
_______________________________________________
yocto mailing list
yocto@yoctoproject.org
https://lists.yoctoproject.org/listinfo/yocto

Reply via email to