The optional SPI bus chapter was missing in the content list.
While at it also place it together with the other "optional" chapters,
instead of in the end.
Signed-off-by: Petter Mabäcker <pet...@technux.se>
---
README | 28 +++++++++++++++-------------
1 file changed, 15 insertions(+), 13 deletions(-)
diff --git a/README b/README
index 16ac1cb..a168692 100644
--- a/README
+++ b/README
@@ -20,10 +20,11 @@ Contents:
2.F. Optional - Video camera support with V4L2 drivers
2.G. Optional - Enable offline compositing support
2.H. Optional - Enable kgdb over console support
- 2.I. Images
- 2.J. Boot to U-Boot
- 2.K. Image with Initramfs
- 2.L. Device tree support
+ 2.I. Optional - Enable SPI bus
+ 2.J. Images
+ 2.K. Boot to U-Boot
+ 2.L. Image with Initramfs
+ 2.M. Device tree support
3. Extra apps
3.A. omxplayer
4. Source code and mirrors
@@ -145,7 +146,13 @@ To add the kdbg over console (kgdboc) parameter to the
kernel command line,
set this variable in local.conf:
ENABLE_KGDB = "1"
-2.I. Images
+2.I. Optional - Enable SPI bus
+==============================
+When using device tree kernels, set this variable to enable the SPI bus
+ENABLE_SPI_BUS = "1"
+
+
+2.J. Images
===========
* rpi-hwup-image
Hardware up image
@@ -155,7 +162,7 @@ ENABLE_KGDB = "1"
Image based on rpi-basic-image which includes most of the packages in this
layer and some media samples.
-2.J. Boot to U-Boot
+2.K. Boot to U-Boot
===================
To have u-boot load kernel image, set in your local.conf
KERNEL_IMAGETYPE = "uImage"
@@ -163,7 +170,7 @@ KERNEL_IMAGETYPE = "uImage"
This will make kernel.img be u-boot image which will load uImage.
By default, kernel.img is the actual kernel image (ex. Image).
-2.K. Image with Initramfs
+2.L. Image with Initramfs
=========================
To build an initramfs image :
* Set this 3 kernel variables (in linux-raspberrypi.inc for example)
@@ -176,7 +183,7 @@ To build an initramfs image :
* Set the meta-rasberrypi variable (in raspberrypi.conf for example)
- KERNEL_INITRAMFS = "-initramfs"
-2.L. Device tree support
+2.M. Device tree support
=========================
Device tree for RPi is only supported when using linux-raspberrypi 3.18+
kernels.
@@ -189,11 +196,6 @@ kernels.
NOTE: KERNEL_DEVICETREE is default enabled for kernel >= 3.18 and always
disabled for
older kernel versions.
-2.M. Optional - enable SPI bus
-==============================
-When using device tree kernels, set this variable to enable the SPI bus
-ENABLE_SPI_BUS = "1"
-
3. Extra apps
=============
--
1.9.1
--
_______________________________________________
yocto mailing list
yocto@yoctoproject.org
https://lists.yoctoproject.org/listinfo/yocto
