Please add
FILES_PN = "${prefix}/local/*" line in your recipe.Thanks, yukatharsani J. On 28-11-2014 14:50, Chan Kit Yu wrote:
Not sure if you wanna read through the log file. I was initially dumbfounded but reading through the log I think I found the issue. Here's the main error (I think) that could have caused the failure. (my package name is "folder"): ERROR: folder not found in the base feeds (valleyisland_64 corei7-64-intel-common corei7-64 core2-64 x86_64 noarch any all). I also attached the error log so feel free to parse it if you feel like it. Thanks, Chan Kit On Fri, Nov 28, 2014 at 4:40 PM, Chris Tapp <opensou...@keylevel.com> wrote:On 28 Nov 2014, at 01:55, Chan Kit Yu <yuchan...@gmail.com> wrote:I would also like to add that bitbaking that recipe alone was fine but bitbaking my image to include that package failed.I'm not sure what's going on - can you post the error message (or at least the relevant part)?On Fri, Nov 28, 2014 at 9:43 AM, Chan Kit Yu <yuchan...@gmail.com> wrote:Hi Chris, Thank you very much :-) But it was no good. I still get the same error even with the "install" use. Here I attach the full recipe just in case I did wrong somewhere: SUMMARY = "Create /usr/local" SECTION = "meta-networking" LICENSE = "MIT" LIC_FILES_CHKSUM = "file://${COMMON_LICENSE_DIR}/MIT;md5=0835ade698e0bcf8506ecda2f7b4f302" #INSANE_SKIP_${PN} = "installed-vs-shipped" do_install(){ install -d ${D}${prefix}/local/ } Chan Kit On Fri, Nov 28, 2014 at 5:00 AM, Chris Tapp <opensou...@keylevel.com> wrote:On 27 Nov 2014, at 07:09, Chan Kit Yu <yuchan...@gmail.com> wrote:Hi all, I'm not sure if emailing this is the most appropriate way and I apologize in advance if that's not. I have some scripts that require /usr/local to exist in Yocto and therefore I need to a recipe to create /usr/local directory. I tried to accomplish this with a simple recipe but that proved futile. Although bitbaking that particular recipe was fine, trying to include that package in local.conf resulted errors and those errors are gibberish (it listed all the packages inside the image that I was trying to comple) . Here's my simple stupid recipe: SUMMARY= "...." LICENSE = "something...." ... ... INSANE_SKIP_${PN} = "installed-vs-shipped" do_install(){ mkdir -p ${D}/usr/local }You need to use 'install' rather than mkdirIs there a better way (or preferably the canonical way) to do this?Yes, there are some definitions you can use. In your case it would be: # Install the 'local' directory to make sure it exists install -d ${D}${prefix}/local # Install a file to this location install -f ${WORKDIR}/myfile ${D}${prefix}/local The available definitions are shown at the top of meta/conf/bitbake.conf in your Poky installation. -- Chris Tapp opensou...@keylevel.com www.keylevel.com ---- You can tell you're getting older when your car insurance gets real cheap!-- Chris Tapp opensou...@keylevel.com www.keylevel.com ---- You can tell you're getting older when your car insurance gets real cheap!
-- _______________________________________________ yocto mailing list yocto@yoctoproject.org https://lists.yoctoproject.org/listinfo/yocto
