Ahh that sounds like you got a DMS-59 connector (not exactly custom). These provide two single-link dvi signals only, they aren't dual-link capable (though they are capable of carrying vga too, if it's wired up). (Theoretically you could drive higher resolutions by using much lower refresh rates over single link but I'm not too sure monitors exist which would accept them...)
Roland Am 31.10.2012 02:49, schrieb Johan Mazel: > There is no VGA output on the HD5450/6350. > There is only a single custom output that is split into two DVI > through a special cable. > > Thanks for all your help guys, but I'm stuck at 1920x1200 until I > upgrade to a bigger card. :/ > Johan > > 2012/10/31 Felix Miata <mrma...@earthlink.net>: >> Does the HD 5450 have a VGA output? Does the U3011 have VGA input? If yes to >> both, can you try that way and get 2560x1600? >> -- >> "The wise are known for their understanding, and pleasant >> words are persuasive." Proverbs 16:21 (New Living Translation) >> >> Team OS/2 ** Reg. Linux User #211409 ** a11y rocks! >> >> Felix Miata *** http://fm.no-ip.com/ >> _______________________________________________ >> xorg@lists.x.org: X.Org support >> Archives: http://lists.freedesktop.org/archives/xorg >> Info: http://lists.x.org/mailman/listinfo/xorg >> Your subscription address: johan.ma...@gmail.com > _______________________________________________ > xorg@lists.x.org: X.Org support > Archives: http://lists.freedesktop.org/archives/xorg > Info: http://lists.x.org/mailman/listinfo/xorg > Your subscription address: rscheidegger_li...@hispeed.ch > _______________________________________________ xorg@lists.x.org: X.Org support Archives: http://lists.freedesktop.org/archives/xorg Info: http://lists.x.org/mailman/listinfo/xorg Your subscription address: arch...@mail-archive.com
