Ben Bucksch wrote:
On 07.01.2012 17:40, Chase Douglas wrote:
Are you sure you are running that version of the driver? Did you change
drivers since you posted your evtest log? The evtest log shows
BTN_TOOL_FINGER being registered, but the upstream driver does not
register it.
The log I posted was from an older Linux kernel. As I wrote back then,
it was a Ubuntu 11.10 kernel 3.0.0-14-generic. I then got linux 3.1.5
and modified the driver there, that's the patch I sent. IIRC (!) I also
tried unchanged linux 3.1.5 and that showed the same problem as the
Ubuntu kernel. So, if I'm not mistaken (see IIRC), my patch did cause a
positive change, but also a negative one.
I am now using linux 3.2 and the touchscreen doesn't work *at all*, but
I use a different .config, so that could be messup here, I'll have to
check.
There is a fair amount of confusion in this thread! The maXTouch chips
can work in i2c or USB HID mode. The evtest log was from the USB HID
mode. The atmel_mxt_ts.c driver is only for i2c. So it's impossible that
the changes that Chase is suggesting would have any effect.
Some more dmesg output would be useful, but it sounds like it's using
the generic HID driver.
Hardcoding relative/absolute in the driver is a bit of a red herring
since it depends on the particular hardware device as to what it's being
used for.
_______________________________________________
xorg@lists.x.org: X.Org support
Archives: http://lists.freedesktop.org/archives/xorg
Info: http://lists.x.org/mailman/listinfo/xorg
Your subscription address: arch...@mail-archive.com
