On Fri, 21 Oct 2011, Tamas Papp wrote: > and button events are detected, but the cursor doesn't move. xinput > test reveals that the X and Y axes are a[2] and a[3]: > > $ xinput test 21 # (excerpt) > motion a[0]=1130 a[1]=525 a[2]=946 a[3]=0 a[4]=0 a[5]=0 > motion a[6]=0 a[7]=0 a[8]=0 a[9]=0 a[10]=0 a[11]=0 > motion a[12]=0 > button press 1 > motion a[0]=1130 a[1]=525 a[2]=1002 a[3]=92 a[4]=0 a[5]=0 > motion a[6]=0 a[7]=0 a[8]=0 a[9]=0 a[10]=0 a[11]=0 > motion a[12]=0 > motion a[0]=1130 a[1]=525 a[2]=1012 a[3]=92 a[4]=0 a[5]=0 > motion a[6]=0 a[7]=0 a[8]=0 a[9]=0 a[10]=0 a[11]=0 > motion a[12]=0 > motion a[0]=1130 a[1]=525 a[2]=1021 a[3]=92 a[4]=0 a[5]=0 > motion a[6]=0 a[7]=0 a[8]=0 a[9]=0 a[10]=0 a[11]=0 > motion a[12]=0 > > Is there a way I could remap these to the appropriate axes so that the > cursor would move on the screen? Sorry if this is a dumb question, I > know very little about Xinput internals. xorg.conf or command line > snippets or documentation on how to do this would be appreciated. I > tried xinput set-prop but couldn't figure it out.
Hi, I found a thread in the archives that talks about a similar problem: http://www.mail-archive.com/xorg@lists.freedesktop.org/msg09731.html $ cat /proc/bus/input/devices reports I: Bus=0003 Vendor=188c Product=0221 Version=1001 N: Name="EPOS EPOS Pen Digitizer." P: Phys=usb-0000:00:1d.0-2/input0 S: Sysfs=/devices/pci0000:00/0000:00:1d.0/usb6/6-2/6-2:1.0/input/input41 U: Uniq= H: Handlers=mouse1 event23 B: PROP=0 B: EV=1b B: KEY=c01 7001f 0 0 0 0 B: ABS=ff000100000f B: MSC=10 but I am still unclear on what I should do to solve this. Best, Tamas _______________________________________________ xorg@lists.freedesktop.org: X.Org support Archives: http://lists.freedesktop.org/archives/xorg Info: http://lists.freedesktop.org/mailman/listinfo/xorg Your subscription address: arch...@mail-archive.com
