I have a simliar problem with a syncmaster 763mb and X where I get flickering from other electrical interference. It almost seems that the frequency isn't set correctly. My XF86Config file has a range which is correct for the monitor. How does Xfree86 determine the needed freqency and how do you determine the actual frequency that it is currenly on. The monitor is brand new and the electrical supply is filtered by a ups. Can seem to figure out what it could be or anyone to assist me.
Number of line * number of points/line * Refresh rate = Bdandwidth.
There is a protocol between the computer and the terminal that allows X to know the caracteristics of the screen. But, I do not know this protocol and the contents of the informations.
Ed Wagner
Marcin Okraszewski <[EMAIL PROTECTED]> wrote:
I have installed Gentoo on my Medion MAM2020 notebook. It uses S3 Savage chip. When I set driver to "savage" the screen fickers (yes, LCD screen fickers!), while changing it to "vesa" makes it OK.
Here is XF86Config extract:
Section "Monitor" Identifier "lcd" HorizSync 31.5-48.5 VertRefresh 50-70 EndSection
Section "Device" Identifier "savage" Driver "vesa" EndSection
Section "Screen" Identifier "screen1" Device "savage" Moniotor "lcd" DefaultDepth 24
SubSection "Display" Depth 24 Modes "1024x768" ViewPort 0 0 EndSection EndSection
Any idea, what do I wrong?
Regards, Marcin Okraszewski
_______________________________________________ XFree86 mailing list [EMAIL PROTECTED] http://XFree86.Org/mailman/listinfo/xfree86
------------------------------------------------------------------------
Do you Yahoo!?
Free Pop-Up Blocker - Get it now <http://us.rd.yahoo.com/slv/mailtag/*http://companion.yahoo.com/>
_______________________________________________ XFree86 mailing list [EMAIL PROTECTED] http://XFree86.Org/mailman/listinfo/xfree86
