According to Akira Taniguchi <[EMAIL PROTECTED]> (on 08/22/03): > > You might also want to play with the SetMClk option. > > I do not know how about with SetMClk option. > Shall you teach me that ? > In my case, please read three files.
The point I was making with the SetMClk option was that perhaps the 65548 is pushing the video memory a bit too hard, either as a design flaw or due to the age of the machine. This might result in video corruption if the memory can't keep up. When you have acceleration enabled, the video bandwidth is shared between the normal linear framebuffer and the bitblt engine, causing a larger load on the memory than when there is no acceleration enabled. Slowing the memory clock might improve this situation. The format of the option is something like Option "SetMClk" "38.000MHz" However, the memory dislikes the algorithms used in the clock selection code of the chips driver, where accuracy of the clock is preferred over clocks with larger PLL division ratios and thus a larger amount of spurious signals in the oscillator output. Thus a poor choice of memory clock will result in its own set of corruption. The other thing I suggested you try, was cycle between the outputs LCD -> LCD/CRT -> CRT -> LCD and see what happens while X is running. This allows the BIOS to reprogram the video registers, perhaps fixing the problem. If the problem is resolved by doing this, then figuring out what the BIOS is doing will resolve your problem... D. -- David Bateman [EMAIL PROTECTED] Motorola CRM +33 1 69 35 48 04 (Ph) Parc Les Algorithmes, Commune de St Aubin +33 1 69 35 77 01 (Fax) 91193 Gif-Sur-Yvette FRANCE The information contained in this communication has been classified as: [x] General Business Information [ ] Motorola Internal Use Only [ ] Motorola Confidential Proprietary _______________________________________________ XFree86 mailing list [EMAIL PROTECTED] http://XFree86.Org/mailman/listinfo/xfree86
