Try a gtf-based modeline generator like "gtf" in the XFree86 4.3
prerelease snapshots. Trying that, I get:
# 1152x864 @ 100.00 Hz (GTF) hsync: 91.50 kHz; pclk: 143.47 MHz
Modeline "1152x864_100.00" 143.47 1152 1232 1360 1568 864 865 868 915 -HSync
+Vsync
Mark.
On Fri, 7 Feb 2003, Eric Mangold wrote:
> Hi,
>
> I'm trying to setup Xfree86 4.2.1 for use with my Elements 9D monitor and a
> GeForce2MX 200 graphics card. It is currently working fine with the nvidia
> driver.
>
> The problem is that X is setting my monitor to 75Hz at 1152x864. The
> monitor is capable of 100Hz at that resolution, and that's what I'm running
> at under Windows. I've tried running "X -configure" but that doesn't do
> anything special with regard to my monitor. I've also played with
> xvidtune, secifically adjusting the width and height in order to raise the
> refresh rate a bit. I havn't been able to make it operate above ~84Hz
> while still being able to compensate with the physical monitor controls. In
> other words, anything higher and I can no longer keep the picture at the
> right physical dimensions.
>
> Thanks in advance,
> -Eric Mangold
>
> My XF86Config-4 file is shown below:
>
Section "Monitor"
Identifier "Generic Monitor"
HorizSync 30-95
VertRefresh 50-150
Option "DPMS"
# This will get me to 84Hz, though I'll be damned if it doesn't add a
bit of distortion
# Modeline "1152x864" 108.00 1152 1216 1344 1428 864 865
868 900 +hsync +vsync
EndSection
_______________________________________________
XFree86 mailing list
[EMAIL PROTECTED]
http://XFree86.Org/mailman/listinfo/xfree86
