[XFree86] new devloper

hi i sent you an email some time ago but have not got any reply

i need some help FAST! as the driver is now veary close to ready !!

can you let me know even if some one is looking into it i think this

is a vary good driver and i wont to get it relest as soon as!!

i am know using ./accel/nvxf for my driver

the email i sent you is

hi i am writing a new driver for xfree86

A long time ago i registered is an xf-developer working on an S3 driver but the

S3 driver did not go any ware and it is now closed but i think i am stall registered

for that project so can someone help me close the S3 project and open my new one ?

my new driver is called NVXF for (NVIDIA xfree86)

i no there is all ready a NV driver for xfree but this driver is so different

it supports full hardware accel 2D / 3D 32 bpp on (NV04 , NV05) chips (NV1x - NV2x) soon

it uses DMA for 2D / 3D commands and most image transfers

and has BIOS level init code for non boot cards

the driver is about 80% written for 3.3.6 i want to parallel build the 4.x.x driver

at the same time as the 3.3.6 as the HW cores are the same

can i have the GLX 3D part in the driver itself for 3.3.6 and 4.x.x ?

i have some problems

to start quickly i just roat over the I128 driver in xc/programs/Xserver/hw/xfree86/accel/i128

so i need help on how to properly link my driver in

if possible i wold like the dir xc/programs/Xserver/hw/xfree86/accel/nvxf for 3.3.6

and xc/programs/Xserver/hw/xfree86/drivers/nvxf for 4.x.x

can some one help me on where to put the reference to my driver in the Makefile

and the like

also can i set up a developer mail list for this driver ?

thank you

Reply via email to