Hi, Thanks for your effort!
> -----Ursprüngliche Nachricht----- > Von: Julien Grall <jul...@xen.org> > Gesendet: Montag, 23. November 2020 19:42 > An: Rahul Singh <rahul.si...@arm.com>; Leo Krueger > <leo.krue...@zal.aero> > Cc: Stefano Stabellini <stefano.stabell...@xilinx.com>; Peng Fan > <peng....@nxp.com>; bru...@xilinx.com; Cornelia Bruelhart > <cornelia.bruelh...@zal.aero>; oleksandr_andrushche...@epam.com; xen- > de...@lists.xenproject.org; Bertrand Marquis > <bertrand.marq...@arm.com> > Betreff: Re: Xen data from meta-virtualization layer > > > > On 23/11/2020 11:41, Rahul Singh wrote: > > Hello , > > Hi Rahul, > > >> On 22 Nov 2020, at 10:55 pm, Leo Krueger <leo.krue...@zal.aero> wrote: > >> root@kontron-sal28:~# ip link set up dev gbe0 > >> (XEN) vgic-v3-its.c:902:d0v0 vITS cmd 0x0c: 000000170000000c > >> 0000000000000001 0000000000000000 0000000000000000 > >> (XEN) vgic-v3-its.c:902:d0v0 vITS cmd 0x05: 0000000000000005 > 0000000000000000 0000000000000000 0000000000000000 > >> [ 34.034598] Atheros 8031 ethernet 0000:00:00.3:05: attached PHY driver > [Atheros 8031 ethernet] (mii_bus:phy_addr=0000:00:00.3:05, irq=POLL) > >> [ 34.041111] 8021q: adding VLAN 0 to HW filter on device gbe0 > >> [ 34.041209] IPv6: ADDRCONF(NETDEV_UP): gbe0: link is not ready > >> root@kontron-sal28:~# [ 35.041951] fsl_enetc 0000:00:00.0 gbe0: Link is > Down > >> [ 38.114426] fsl_enetc 0000:00:00.0 gbe0: Link is Up - 1Gbps/Full - flow > control off > >> [ 38.114508] IPv6: ADDRCONF(NETDEV_CHANGE): gbe0: link becomes > ready > >> > >> Does that tell you anything? > >> > > > > I just checked the logs shared, what I found out that there’s is an error > while booting to configure the MSI for the PCI device because of that there > will be case that Device Id generate out-of-band is not mapped correctly to > ITS device table created while initialising the MSI for the device. > > I might be wrong let someone else also comments on this. > > I think there might be multiple issues. You spotted one below :). > > > [ 0.173964] OF: /soc/pcie@1f0000000: Invalid msi-map translation - no > match for rid 0xf8 on (null) > > Leo, just to confirm, this error message is not spotted when booting Linux on > baremetal? In fact it is: [ 0.160077] OF: /soc/pcie@1f0000000: Invalid msi-map translation - no match for rid 0xf8 on (null) But everything works as expected here: 110: 34288 0 ITS-MSI 1 Edge gbe0-rxtx0 111: 0 6196 ITS-MSI 2 Edge gbe0-rxtx1 > > Cheers, Best wishes > > -- > Julien Grall
