On 2020-06-16 19:13, CodeWiz2280 wrote:
On Tue, Jun 16, 2020 at 4:11 AM Marc Zyngier <m...@kernel.org> wrote:
On 2020-06-15 20:14, CodeWiz2280 wrote:
[...]
> Also, the latest linux kernel still has the X-Gene storm distributor
> address as "0x78010000" in the device tree, which is what the Xen code
> considers a match with the old firmware. What were the addresses for
> the device tree supposed to be changed to?
We usually don't care, as the GIC address is provided by the
bootloader,
whether via DT or ACPI (this is certainly what happens on Mustang).
Whatever is still in the kernel tree is just as dead as the platform
it
describes.
> Is my understanding
> correct that there is a different base address required to access the
> "non-secure" region instead of the "secure" 0x78010000 region? I'm
> trying to see if there are corresponding different addresses for the
> keystone K2E, but haven't found them yet in the manuals.
There is no such address. Think of the NS bit as an *address space*
identifier.
The only reason XGene presents the NS part of the GIC at a different
address is because XGene is broken enough not to have EL3, hence no
secure mode. To wire the GIC (and other standard ARM IPs) to the core,
the designers simply used the CPU NS signal as an address bit.
On your platform, the NS bit does exist. I strongly suppose that it
isn't wired to the GIC. Please talk to your SoC vendor for whether iot
is possible to work around this.
I do have a question about this out to TI, but at least this method
gives me something to work with in the meantime. I was just looking
to confirm that there wouldn't be any other undesirable side effects
with Dom0 or DomU when using it. Was there an actual FPGA for the
X-Gene that needed to be updated which controlled the GIC access? Or
by firmware do you mean the boot loader (e.g. uboot). Thanks for the
support so far to all.
As I said, the specific case of XGene was just a matter of picking the
right address, as the NS bit is used as an address bit on this platform.
This was possible because this machine doesn't have any form of
security. So no HW was changed, no FPGA reprogrammed. Only a firmware
table was fixed to point to the right spot. Not even u-boot or EFI was
changed.
M.
--
Jazz is not dead. It just smells funny...
