This causes u-boot to fill in the various fields in the chosen node
(specifically the bootargs) which would otherwise not be done until
the bootz command. Doing it manually means the following "fdt print
/chosen" will print what is actually going to be used.
This change means that instead of whatever /chosen/bootargs is
embedded in the firmware FDT we end up printing what we will actually
use.
Signed-off-by: Ian Campbell <ian.campb...@citrix.com>
---
Osstest/Debian.pm | 2 ++
1 file changed, 2 insertions(+)
diff --git a/Osstest/Debian.pm b/Osstest/Debian.pm
index 7633b51..f6874af 100644
--- a/Osstest/Debian.pm
+++ b/Osstest/Debian.pm
@@ -237,6 +237,8 @@ fdt set /chosen/module\@1 compatible "xen,linux-initrd"
"xen,multiboot-module"
fdt set /chosen/module\@1 reg <\\\${ramdisk_addr_r}
${size_hex_prefix}\\\${filesize}>
echo Loaded $initrd to \\\${ramdisk_addr_r} (\\\${filesize})
+fdt chosen
+
fdt print /chosen
echo Booting \\\${xen_addr_r} - \\\${fdt_addr}
--
2.1.4
_______________________________________________
Xen-devel mailing list
Xen-devel@lists.xen.org
http://lists.xen.org/xen-devel
