Yes, The Signalink goes to the data port and I have a usb CAT cable. It has been working fine for years, and works fine on 2.5.4, but the 2.6.0-rc1 does not allow me to select VOX PTT. When I do, it fails to connect to the CAT. Works fine when I install the 2.5.4 version using the same settings. When using the signalink, the audio goes through the data port. You must select VOX for the rig to use audio on this port. Using CAT will not send audio from the data port. It will key the rig, but wont modulate because its looking for audio on the mic connector only.
From: Adrian <[email protected]> Sent: Sunday, July 10, 2022 10:31 AM To: WSJT software development <[email protected]> Cc: Nigel Haynes <[email protected]> Subject: Re: [wsjt-devel] FT-857 rig control bug in WSJT-X 2.6.0-rc1 The cat port doesn't have any audio connections. The signal-link should be using the data port. Do you have a cat cable fitted as well ? I have 897/857 setup for wsjtx with no need for vox using cat ptt, but I do have both CAT and data(sndcd) lines fitted. 73 vk4tux On 11/7/22 00:22, Nigel Haynes via wsjt-devel wrote: cat port on the rear where the signalink is sending the audio
_______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
