OK on that link, however with the CP2105 comports it is best to wsjtx
select the standard comport instead of CAT for PTT,
and use RTS as KI5GFU has RPTT set.
RPORT gain is better at 7 to 10 rather than 25, as this allows better
wsjtx 'TX pwr' linear control, where small adjustments result in audio
levels results when setting alc meter minimum. Higher (default) RPORT
Gain results in a compressed audio zone causing TX gain adj steps
to have no effect over a certain range and compromised signal quality.
73
vk4tux
On 24/6/22 08:12, Black Michael via wsjt-devel wrote:
From my notes helping somebody else.
FTDX-10 Data/Pkt mode bandwidth not working..had to use USB mode Data
Out Level=0 (!!!!)
Some more info
https://ki5gfu.com/2021/10/14/ftdx-10-setting-up-wsjt-x-configuration-for-digital-eg-ft8/
Mike W9MDB
On Thursday, June 23, 2022 at 05:02:21 PM CDT, BRIAN JONES via wsjt-devel
<[email protected]> wrote:
Got the Yaesu FTdx10 a couple of weeks ago and and trying to
get on FT8 everything said I needed a laptop or PC with windows 10/11.
So last Monday I went out & caught one with win11 home installed,
while I was in the shop they got it setup for me with all the updates
etc. sorted. jobs a good one so I thought!
Having used WJST before with a Icom bit of junk the 7300, very similar
settings to the FTdx10. As having set all parameters up to Yaesu and a
lot of the geeks say the same including, downloading virtual ports,
firmware both off Yaesu & BktTimesync; Then loaded WSJT-X . Now on
settings got radio setting done clicks box turns green 1st part sorted
the pressing next button radio goes into TX clicks ok, box closes and
all I keep getting is a box with red circle and X in red ring with
message (ERROR IN SOUND INPUT) but can you tell me where the sound input
is coming from my Radio or my Laptop, then how to stop this error and
get back on the air with FT8 & FT4?
If anyone has a PDF with all settings for windows 11 so all I would need to do is
swop over com port numbers. Up to now I have wasted close to 35 hours trying to get
up & running and up to now no one knows what or where this problem is! Did send
an email to Joe Taylor K1JT even though he sent me to Wiki to find a cure! I had
Icoms NAIL the 7300 ( had four for just one band in the UK 70Mhz ) totally deaf as
a post. But Icom UK recon they can hear signals off a DUMMY LOAD dummies. my email
address is below if anyone has a clue as I don't Thanks.
[email protected]
Regards
Best 73
Brian De M6OXO
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
