You were right, it does load OK on my up-to-date (linux) build. I did notice that the expert info notes a couple of malformed SSL frames... Could you please try to load the attached file? I saved only the frames using the display filter 'wimasncp and not eap'. This will indicate if the problem lies within EAP/SSL or inside wimaxasncp itself.
Another possible difference between yourself and your colleagues may be preference settings you may have. Have you changed any SSL protocol preferences? I still think its worth installing the very latest automated build I linked to earlier to see if the problem persists there. I did try to run Wireshark under valgrind a few minutes ago with your capture, but it didn't get very far... On Feb 11, 2008 3:22 PM, Martin, Jack <[EMAIL PROTECTED]> wrote: > You are correct, I did not build Wireshark myself – I downloaded the > > official 0.99.7 version (several times just to make sure). > > > > I'll attach the capture file I use but others have used 0.99.7 to open > this > > same capture file without any issue. I would not be surprised if you can > > open the file successfully. Note that I have tried 4 or 5 different > > capture files and each time I crash. I do not capture the file(s) > > myself, I am only trying to open a file that was captured by another > > device. Others can open this file and I can open other files that do not > > contain WiMAX. > > > > I can not narrow it down to a frame since when I try and open the file it > > crashes before any frames are displayed. If I disable WiMAX ASN CP > > protocol I can open the file but as soon as I enable that protocol > > (for example after the file is open) it crashes. > > > > > > Thanks. > ------------------------------ > > *From:* [EMAIL PROTECTED] [mailto: > [EMAIL PROTECTED] *On Behalf Of *Martin Mathieson > *Sent:* Monday, February 11, 2008 10:13 AM > > *To:* Community support list for Wireshark > *Subject:* Re: [Wireshark-users] Wireshark crash with WiMAX capture file > > > > Most likely Wireshark is crashing because of a bug in the wimaxasncp > dissector. > > If you are able to send (attach to a bug) a capture file that causes this > problem, I can try to debug it. You can always try to trim the message down > to one frame (disable, wimaxasncp, save the displayed frames, etc until you > narrow it down to the frame that causes the problem. > > If you can't send in a capture file, you'll need to try to get the stack > at the point where it crashes (it looks like you're using the official > 0.99.7 release, so I'm guessing you didn't build Wireshark yourself). You > could try using the most recent development build from > http://www.wireshark.org/download/automated/win32/, although I don't > believe the wimaxasncp dissector has been changed since the release. > > On Feb 11, 2008 3:02 PM, Martin, Jack <[EMAIL PROTECTED]> wrote: > > Here's all I have … (when I open any capture file that has WiMAX R6 > messages > > I get the error and Wireshark closes – nothing is shown in the wireshark > > window before it closes). > > > > > ------------------------------ > > *From:* [EMAIL PROTECTED] [mailto: > [EMAIL PROTECTED] *On Behalf Of *Martin Mathieson > *Sent:* Monday, February 11, 2008 9:56 AM > *To:* Community support list for Wireshark > *Subject:* Re: [Wireshark-users] Wireshark crash with WiMAX capture file > > > > Hi, > > Could you post a capture file showing the problem? > > Best add whatever details you can to bugilla (http://bugs.wireshark.org). > > Martin > > On Feb 11, 2008 2:36 PM, Martin, Jack <[EMAIL PROTECTED]> wrote: > > I downloaded the latest version of Wirshark (0.99.7), but when I try and > > open a capture file that has WiMAX messages (R6 messages) I get a > > windows error report and Wireshark closes. If I disable the WiMAX ASN CP > > protocol I am able to open the file but obviously can not decode the > > WiMAX messages. > > > > I can open (and decode) files with other protocols ( AAA, SIP, GTP, etc > …), > > it appears as if WiMAX is the only thing I'm having trouble with. > > > > Any suggestions on how to fix my issue? > > > > Regards. > > > > > > E-mail confidentiality. > -------------------------------- > This e-mail contains confidential and / or privileged information > belonging to Spirent Communications plc, its affiliates and / or > subsidiaries. If you are not the intended recipient, you are hereby notified > that any disclosure, copying, distribution and / or the taking of any action > based upon reliance on the contents of this transmission is strictly > forbidden. If you have received this message in error please notify the > sender by return e-mail and delete it from your system. If you require > assistance, please contact our IT department at [EMAIL PROTECTED] > > Spirent Communications plc > Northwood Park, Gatwick Road, Crawley, West Sussex, RH10 9XN, United > Kingdom. > Tel No. +44 (0) 1293 767676 > Fax No. +44 (0) 1293 767677 > > Registered in England Number 470893 > Registered at Northwood Park, Gatwick Road, Crawley, West Sussex, RH10 > 9XN, United Kingdom. > > Or if within the US, > > Spirent Communications, > 26750 Agoura Road, Calabasas, CA, 91302, USA. > Tel No. 1-818-676- 2300 > > > _______________________________________________ > Wireshark-users mailing list > Wireshark-users@wireshark.org > http://www.wireshark.org/mailman/listinfo/wireshark-users > > > > > > > > E-mail confidentiality. > -------------------------------- > This e-mail contains confidential and / or privileged information > belonging to Spirent Communications plc, its affiliates and / or > subsidiaries. If you are not the intended recipient, you are hereby notified > that any disclosure, copying, distribution and / or the taking of any action > based upon reliance on the contents of this transmission is strictly > forbidden. If you have received this message in error please notify the > sender by return e-mail and delete it from your system. If you require > assistance, please contact our IT department at [EMAIL PROTECTED] > > Spirent Communications plc, > Northwood Park, Gatwick Road, Crawley, West Sussex, RH10 9XN, United > Kingdom. > Tel No. +44 (0) 1293 767676 > Fax No. +44 (0) 1293 767677 > > Registered in England Number 470893 > Registered at Northwood Park, Gatwick Road, Crawley, West Sussex, RH10 > 9XN, United Kingdom. > > Or if within the US, > > Spirent Communications, > 26750 Agoura Road, Calabasas, CA, 91302, USA. > Tel No. 1-818-676- 2300 > > > _______________________________________________ > Wireshark-users mailing list > Wireshark-users@wireshark.org > http://www.wireshark.org/mailman/listinfo/wireshark-users > > > > > > E-mail confidentiality. > -------------------------------- > This e-mail contains confidential and / or privileged information > belonging to Spirent Communications plc, its affiliates and / or > subsidiaries. If you are not the intended recipient, you are hereby notified > that any disclosure, copying, distribution and / or the taking of any action > based upon reliance on the contents of this transmission is strictly > forbidden. If you have received this message in error please notify the > sender by return e-mail and delete it from your system. If you require > assistance, please contact our IT department at [EMAIL PROTECTED] > > Spirent Communications plc, > Northwood Park, Gatwick Road, Crawley, West Sussex, RH10 9XN, United > Kingdom. > Tel No. +44 (0) 1293 767676 > Fax No. +44 (0) 1293 767677 > > Registered in England Number 470893 > Registered at Northwood Park, Gatwick Road, Crawley, West Sussex, RH10 > 9XN, United Kingdom. > > Or if within the US, > > Spirent Communications, > 26750 Agoura Road, Calabasas, CA, 91302, USA. > Tel No. 1-818-676- 2300 > > > _______________________________________________ > Wireshark-users mailing list > Wireshark-users@wireshark.org > http://www.wireshark.org/mailman/listinfo/wireshark-users > >
idlemodewithpaging-noeap.pcap
Description: Binary data
_______________________________________________ Wireshark-users mailing list Wireshark-users@wireshark.org http://www.wireshark.org/mailman/listinfo/wireshark-users
