Hello, below is a post that Ivan put some months ago .... I have to say that I've seen same or almost the same behaivor in a WAP 11 with 14i.1 firmware ...
A network of WAP11's in client mode and one of the WAP11's in Access point mode ... one of the Clients has a signal strength of around 17% ... after a wile of being not used (packets not passed trougth him) it enters in a "sleep" and if you try to ping again it will take a while (10 to 15 secs) to respond again ... The rest of the Clients (with signals above 50%) works fine and they oing inmediatly. - Is this a comon failure of the WAP's 11 ? - Has anyone devised a Solution ? Salva F Spain ------------------------------------------------ >WAP11 has sleep problem on anyone firmware, >include 1.4i1. >I could not understand long time as it happens >and only a few days back were possible to stage a situation sleep. > >If to install CR31=7Fh (minimum signal) and to disconnect >antennas from plugs that at distance with 50 percentage drop >ping AP, in some minutes AP WAP11 sleep. >The same case if is the interferences. > >WAP11 AP unsleep if to send ping or/and arp through only ethernet. >I hope that the developers now will correct this mistake firmware. -- general wireless list, a bawug thing <http://www.bawug.org/> [un]subscribe: http://lists.bawug.org/mailman/listinfo/wireless
